Coldcraft Effects Echoverberator Coldcraft Effects

From Coldcraft:

After the smash success of the short run EchoVerb, we’ve revised, repackaged and reinvigorated the design into the new EchoVerberator. The ‘Verberator features the same ground-breaking parallel combination of lush, responsive reverb and warm, organic echoes and adds a host of exciting new features.

New for 2015

The 2015 EchoVerberator incorporates our new True Power Bypass. The EchoVerberator is buffered when powered, providing echo and reverb trails in all modes, however should the unit lose power, it will revert to true bypass through a low power latching relay.

Magnetic Tape Voicing

The Echo program features an innovative new wow and flutter modulation that adds subtle pitch wandering to each repeat, just like an Echoplex EP-3. Additional, the input preamp includes a new dynamic filtering algorithm that reproduces the saturation and transient-limiting response of actual magnetic tape.

Buffered Bypass with Trails

The EchoVerberator features a very unique, hybrid preamp that combines a low noise input stage with an opamp-driven output stage. This combination preserves the full range of your signal both into the sound engine and out to your amp. An ambient effect like this usually comes at the end of your pedal board which is the perfect place for a high fidelity buffer to preserve your tone through whatever cable length used, as well as providing smooth transition to bypass with echo and reverb that trail off. Trails function in all modes described below.

All Analog Dry Path

While this is a powerful DSP-based effect, we took the extra time and expense to keep the dry signal pure and analog to maintain the “magic” connection, dynamics and response that only analog can give.

Reverb Always-On Mode*

Inside the pedal there is a dual DIP switch. The rightmost switch toggles “reverb always-on mode” which leaves the reverb permanently connected even in bypass. This is verified by one color of the dual LED staying on constantly. In this mode the footswitch activates and bypasses the Echo effect (with trails when bypassed).

Momentary Bypass Mode

The EchoVerberator can be put into “momentary” mode where effects are triggered only when the footswitch is held down. To enter Momentary Mode, leave the pedal in bypass for >3 seconds, then enter the sequence Tap, Tap, Hold and the LED will blink indicating the Mode change. Repeat to reverse, or unplug/plug the power cord. This mode works in conjunction with the modulation and reverb always on options.